Floor carpet

Cabin interior part

High-tech construction, made of several layers, meets the noise insulation, physico-mechanical and aesthetical requirements.

In the manufacturing process the following technologies are implemented: cold molding, PVC hill pad HF welding and PPU component casting.
Cabin floor carpet cutting is performed at automotive water jet cutting facility.

Trunk floor carpet

Part of trunk interior system

The product is created by baking blanks at heating ovens and their subsequent cutting.

Constituent components make it possible to create a product which meets the noise insulation, physico-mechanical and aesthetical requirements.

Arch wheel trims

Interior part of trunk compartment

The main technology process is heating of the blank in heating ovens, cold molding and cutting.

Constituent components make it possible to create a product that meets the noise insulation, physico-mechanical and aesthetical requirements.

Hood lining

Engine bay compartment part

Manufacturing technology includes hot molding process thermo-forming through heating the material by steam in hot molding form and automatic cutting.

High-tech construction, made of several layers, meets the noise insulation, physico-mechanical and aesthetical requirements.

Boot-lids trim

Interior part of trunk compartment

The main technology process is heating the blank in heating ovens and cold molding.

Constituent components make it possible to create a product that meets the noise insulation, physico-mechanical and aesthetical requirements.

Headliner

Interior system part

Manufacturing process consists of heating the blank in the heating oven, molding at cold molding-form and cutting at automotive water jet cutting facility.

High-tech construction, made of several layers, meets the noise insulation, physico-mechanical and aesthetical requirements.

Rear sit back trim

Interior system part

Manufacturing process consists of heating the blank in the heating oven, molding in cold molding-form and cutting at automotive water jet cutting facility.

Outer dash insulation
Engine bay compartment part

Consists of «heavy layer», created by vacuum molding , and of noise insulating layer, created by PPU component filling.

This construction allows to achieve the best optimal balance between noise insulating and sound absorption characteristics.
Front floor carpet noise insulation

Compartment interior part

«Ultra-light» material is used in production process.
The general design conception was to find the ideal balance among damping, insulation and sound absorption.

This enables us to make a high-quality product that follows all customers’ requirements.

Middle floor carpet noise insulation

Compartment interior part

«Ultra-light» material is used in production process.
The general design conception was to find the ideal balance among damping, insulation and sound absorption.

This enables us to make a high-quality product that follows all customers’ requirements.

Inner dash

Compartment part

Consists of «heavy layer», made by vacuum molding , and of noise insulating layer, made by PPU component filling.

This construction allows to achieve the best combination of noise insulating and sound absorptive characteristics.

Trunk back side trim

Interior part of trunk compartment

Constituent components make it possible to create a product that meets the noise insulation, physico-mechanical and aesthetical requirements.